3M C1060 - A125 Noise Reduction Module Installation; Important Installation Notice for A125 Module; Trimming Base Station Receptacle for A125 Module

12
• Recheck the Talk-Lock function by pressing the L button. The Talk LED on the base station should not
light.
2. Program the Headsets for Cross-Lane Operation
• With the headset OFF, press and hold T1 and
T2 while pressing ON for 5 seconds. You will hear an
acknowledging beep.
• Verify that the headsets are properly programmed for Cross-Lane operation:
- Press T1 and verify that the Talk LED lights on the lane 1 base station and does not light on the
lane 2 base station.
- Press T2 and verify that the Talk LED lights on the lane 2 base station and does not light on the
lane 1 base station.
• To remove the Cross-Lane function and return the headsets to the normal operating mode, first turn the
headset OFF, and then hold down T1 while pressing ON for 5 seconds. You will hear an
acknowledging beep.
Operation
Cross-Lane Module OFF
Vehicle detector alerts
The operator will only hear the vehicle detector alert from the menu sign with which he or she last
talked. Vehicles at menu sign 1 will be heard as a single repeating alert. Vehicles at menu sign 2 will
be heard as a double repeating alert.
Answering customers
Pressing T1 will only allow communication with the lane 1 customer. Pressing T2 will only allow
communication with the lane 2 customer.
Paging function
Pressing T1 will only allow communication with other headsets, which recently pressed T1. Pressing
T2 will only allow communication with other headsets, which recently pressed T2.
Cross-Lane Module ON
Vehicle detector alerts
The operator will always hear both vehicle detector alerts. Vehicles at menu sign 1 will be heard as a
single repeating alert. Vehicles at menu sign 2 will be heard as a double repeating alert.
Answering customers
Pressing T1 will only allow communication with the lane 1 customer. Pressing T2 will only allow
communication with the lane 2 customer.
Paging function
Pressing T1 will only allow communication with other headsets, which recently pressed T1. Pressing
T2 will only allow communication with other headsets, which recently pressed T2.