Introduction
This document will demonstrate how to Program a 3M C1060 Wireless Headset.
Programming the Headset
The 3M Base Station should be turned On (it probably stays on 24-7 in
your store) and the Programming Station should be connected to the
Base Station (again, it probably already is).
The 3M Programming Station
Swing the microphone to one side until it
reaches the built-in stop.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 2
To Next Page
Loading...
