With the microphone and the buttons fac-
ing Up, insert the bottom end of the head-
set into the Programming Station.
While holding the headset firmly
against the Programming Station,
reach under and turn the headset
On.
Watch the LED next to the T2 but-
ton, it should flash Off and On if it’s
“seeing” the Programming Station.
You should also hear a series of
beeps from the headset’s speaker.
Continue to hold the headset in the
programming station until the
beeps and the flashing LED both
stop. When they both stop, pro-
gramming is complete.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 3
To Next Page
Loading...
