Test the Headset
While standing in front of the Base Station push
the “T1” button on the headset and check to en-
sure that the “Talk” indicator on the Base Station
illuminates in Red.
Repeat for the “Page” button and check to ensure
that the “Page” indicator on the Base Station illumi-
nates in Green.
If both illuminate then the programming was suc-
cessful. Put the headset on and talk to a co-worker
as a final test.
If either “Talk” or “Page” fails go back and program
the headset again, double checking to see either
that the LED flashes Green or that you hear the
programming tones from the headset speaker.
ESS 3M C1060 Headset Programming Procedure
ESS, Inc. -- 615-340-9033
3M C1060 Headset - Programming Page 4
To Next Page
Loading...
