Optimizing Inbound audio level:
1. Proper fitting of headset
Make the following adjustments to the headset to make sure it is not only comfortable, less likely to fall off and easy for you to hear
and speak clearly; but to also make sure the speaker on the headset is properly aligned to your ear.
a) Adjust the size of the headband until the ear pad rests against one ear and the comfort pad cushion rests just above the
other ear.
b) To create a tighter fit, hold the headset with one hand on the Pod area and the other hand on the Comfort Pad area.
Gently bring the two hands close to one another, then past one another. Slowly move one end back and forth.
c) This ensures pressure is applied equally along the length of the headband. Applying excessive force in one area alone will
create a crease on the headband.
d) Rotate the microphone boom up or down so its tip is in line with the corner of your mouth. Do not bend the boom.
e) Make sure the headset speaker foam covers your ear.
2. Volume setting on headset
Slide your finger up the Volume control area to raise the volume on the headset.
Volume'Control
To Next Page
Loading...
