Page 16 of 24P/N 595278-01 Rev B 2/18
BATTERY CHARGING, INSTALLATION, AND
REPLACEMENT
WARNING
THE BATTERY PACK MAY EXPLODE, LEAK, OR
CATCH ON FIRE IF DIRECTLY EXPOSED TO HIGH
TEMPERATURE, WATER, OR FIRE, OF IF OPENED,
DISASSEMBLED, OR TAMPERED WITH. FAILURE
TO HANDLE THE BATTERY PROPERLY MAY RE-
SULT IN SERIOUS INJURY.
BATTERY CHARGING FOR THE HAND HELD RECEIVER
Power for the Hand Held Receiver is provided by a rechargeable Nickel-Metal
Hydride (Ni-MH) battery pack P/N 200402-02. The battery pack must be fully
charged before placing the Hand Held Receiver in service.
DO NOT REMOVE, RE-CHARGE, OR REPLACE THE BATTERY PACK WHILE
THE DEVICE IS IN A HAZARDOUS LOCATION.
CONSULT FEDERAL, STATE, AND LOCAL REGULATIONS REGARDING
DISPOSAL OF RECHARGEABLE NI-MH BATTERIES. The Desk Top Battery
Charger, (P/N 200434-01) requires 90-240 VAC.
If the Battery Charger does not operate as described in these instructions,
remove it from service and tag it for repair or replacement.
1. Plug the battery charger power supply into 90-240 VAC current.
2. Plug the charger power supply cord into the charger base. See FIGURE
5. When the charger is connected to power, the charging light LED will
ash once in RED, ORANGE and GREEN in that order. The charging
light indicator LED will then go off.
4. The Battery pack only ts in the charger one way. Orient the battery with
the ridge side up and the triangular side of the Battery Pack down with the
pull tab out. See FIGURE 6.
5. Slide the Battery Pack into the charger until the pull tab end seats in the
bracket on the front of the charger.
The light on the right ashes green while the battery is charging.
3. Identify the location of the three battery contacts on the end of the Battery
Pack. Verify that they are clean and not damaged. If there is any evidence
of damage, do not use the battery pack. Refer to the MAINTENANCE
section of this instruction.
FIGURE 5
CHARGING
LIGHT
WARNING
THE DESK TOP BATTERY CHARGER IS DESIGNED
TO CHARGE ONLY THE RECHARGEABLE NICKEL-
METAL HYDRIDE (NI-MH) BATTERY PACK, SCOTT
SAFETY P/N 200402-02. USING THE CHARGER TO
CHARGE ANY OTHER BATTERY CONFIGURATION
WILL RESULT IN DAMAGE TO THE CHARGER AND
POSSIBLE EXPLOSION OR FIRE, WHICH COULD
CAUSE SERIOUS INJURY OR DEATH.
FIGURE 6
BATTERY FITS
ONLY ONE WAY
WARNING
REPLACE THE HAND HELD RECEIVER BATTERY
PACK ONLY WITH SCOTT BATTERY PACK, PART
NO. 200402-02. DO NOT REMOVE, RE-CHARGE, OR
REPLACE THE BATTERY PACK WHILE THE DEVICE
IS IN A HAZARDOUS LOCATION. REMOVING, RE-
CHARGING, OR REPLACING THE BATTERY PACK
WHILE THE DEVICE IS IN A HAZARDOUS LOCA-
TION MAY LEAD TO A FIRE OR AN EXPLOSION,
WHICH COULD RESULT IN SERIOUS INJURY OR
DEATH.
To Next Page
Loading...