3M Scott Pak-Tracker - Battery Installation for the Hand Held Receiver

Page 17 of 24 P/N 595278-01 Rev B 2/18
WARNING
DISPOSE OF DAMAGED BATTERIES IN ACCOR-
DANCE WITH FEDERAL, STATE, AND LOCAL
ENVIRONMENTAL REGULATIONS. DO NOT THROW
AWAY DAMAGED BATTERIES AS ORDINARY
TRASH. FAILURE TO HANDLE BATTERY PROP-
ERLY MAY RESULT IN SERIOUS INJURY.
An optional Truck-mount Charging System (TCS) is also available to charge the
Hand Held Receiver battery while installed in the unit. Contact Scott Safety or your
authorized Scott Safety dealer or distributor for details, or refer to the instructions
provided with the TRUCK-MOUNT CHARGING SYSTEM.
6. When the battery is fully charged, the light changes to solid green. The
battery will require approximately 2 hours charging prior to initial use. After
each use of the Hand Held Receiver, recharge the battery until the light
turns solid green.
7. To remove the battery from the charger, press the battery catch and slide
the battery out.
8. Recharge batteries on a regular basis (such as once per week) to maintain
a full charge ready for use.
9. If the light in the charger base glows yellow, the charger is in STANDBY
mode.
10. If the light on the charger base ashes red as soon as a battery is placed
in the charger, there is a defect in the battery. Remove the battery from
service and dispose of according to federal, state, and local regulations.
BATTERY INSTALLATION FOR THE HAND HELD RECEIVER
The PAK-TRACKER Hand Held Receiver uses a single specially designed
Rechargeable Battery Pack (Scott Safety P/N 200402-02). Changed the battery
pack only in an area known to be nonammable. Install the battery as follows:
1. Verify that Rechargeable Battery Pack is fully charged. See BATTERY
CHARGING FOR THE HAND HELD RECEIVER in this instruction.
2. Inspect the Battery Pack before installing. Verify that there is no damage
to the outer plastic cover and that the contacts are clean and not damaged.
If there is any evidence of damage, do not use the Battery Pack. See the
MAINTENANCE section of this instruction.
3. Remove the threaded cover from the bottom of the Hand Held Receiver
handle by turning it counterclockwise.
4. The Rechargeable Battery Pack is triangular with a ridge on one side and
will t into the handle only one way. Hold the Battery Pack by the end with
the pull tab and slide the contact end into the handle. There is an arrow
under the pull tab indicating the top side of the battery. If properly oriented,
the Battery Pack slides easily into the handle. See FIGURE 7. If oriented
incorrectly, the pack will not t into the handle. DO NOT FORCE.
FIGURE 7
PULL TAB
RIDGE ON
TOP SIDE OF
BATTERY
NOTE
BE CAREFUL TO NOT PRESS ANY BUTTONS ON THE HAND HELD RE-
CEIVER WHILE INSERTING THE BATTERY. IF YOU DO, REMOVE THE
BATTERY AND REINSERT IT.
WARNING
DO NOT USE THE HAND HELD RECEIVER IN A
POTENTIALLY EXPLOSIVE OR FLAMMABLE AT-
MOSPHERE. ALWAYS CHECK FOR THE PRESENCE
OF A FLAMMABLE OR EXPLOSIVE ATMOSPHERE
BEFORE ENTERING AN UNKNOWN ATMOSPHERE
WITH THE HAND HELD RECEIVER. USE OF THE
HAND HELD RECEIVER IN A FLAMMABLE OR EX-
PLOSIVE ATMOSPHERE MAY RESULT IN IGNITION
OF THE ATMOSPHERE, RESULTING IN SERIOUS
INJURY OR DEATH.