9
Adjusting the projector's elevator
When the place to put the projector is slightly uneven to the left or right, use the 
elevator feet to place the projector horizontally. 
Using the feet can also tilt the projector in order to project at 
a suitable angle to the screen, elevating the front side of the 
projector within 8 degrees.
This projector has 2 elevator feet and 2 elevator knobs. An elevator foot is 
adjustable while pulling up the elevator knob on the same side as it.
1.
Holding the projector, pull the elevator knobs up to loose the elevator feet.
2.
Position the front side of the projector to the desired height.
3.
Release the elevator knobs in order to lock the elevator feet.
4.
After making sure that the elevator feet are locked, put the projector gently.
5.
If necessary, the elevator feet can be manually twisted to make more precise 
adjustments. Hold the projector when twisting the feet.
Setting up
To loose an elevator foot, 
pull up the elevator knob 
on the same side as it.
CAUTION Ź'RQRWKDQGOHWKHHOHYDWRUNQREVZLWKRXWKROGLQJWKHSURMHFWRU
since the projector may drop down.
Ź'RQRWWLOWWKHSURMHFWRURWKHUWKDQLWHOHYDWLQJLWVIURQWZLWKLQGHJUHHVXVLQJ
the adjuster feet. A tilt of the projector exceeding the restriction could cause 
malfunction or shortening the lifetime of consumables, or the projector itself.
Using the security bar and slot
A commercial anti-theft chain or wire up to 10 mm in 
diameter can be attached to the security bar on the 
projector. 
Also this product has the security slot for the Kensington 
lock.
For details, see the manual of the security tool.
CAUTION Ź'RQRWXVHWKHVHFXULW\EDUDQGWKH
security slot to prevent the projector from falling down, 
since it is not designed for it.
NOTE  • 
The security bar and the security slot are not 
comprehensive theft prevention measures. They are intended 
to be used as supplemental theft prevention measure.
7R¿QHO\DGMXVWWZLVW
the foot.
q
Security slot
Anti-theft chain or wire
Security bar
3M™ Digital Projector X90
© 3M 2007.  All Rights Reserved.