3M X90w User Manual (English)

Other manuals for 3M X90w

Manual84 pages

Specifications4 pages

Operator's Guide73 pages

Application Guide86 pages

Questions and Answers:

R
rhamiltonAug 8, 2025
What to do if 3M X90w Projector shows 'Check the Air Flow'?
- N
  Nathaniel MyersAug 8, 2025
  If your 3M Projector displays a 'Check the Air Flow' message, it indicates the internal temperature is rising. Turn the power off and let the projector cool down for at least 20 minutes. Then, check for any blockage of the air passage, if the air filter is dirty, and if the surrounding temperature exceeds 35°C. After addressing these issues, power the unit on again. If the message persists, set the FAN SPEED in the SERVICE menu to HIGH.
M
Malik MunozAug 13, 2025
What to do if 3M X90w Projector says 'No Input is Detected'?
- D
  Dylan AyalaAug 13, 2025
  If your 3M Projector displays 'No Input is Detected', confirm the signal input connection and check the status of the signal source.
M
moranethanAug 18, 2025
Why does my 3M X90w Projector say 'Sync is Out of Range'?
- D
  dustinwelchAug 18, 2025
  If your 3M Projector displays 'Sync is Out of Range', confirm the specifications for your projector or the signal source specifications.
K
Kayla WeaverAug 23, 2025
What to do if 3M X90w Projector says 'Check the air flow'?
- L
  lboydAug 25, 2025
  If your 3M Projector displays 'Check the air flow', it means the internal temperature is rising. Turn the power off and let the projector cool down for at least 15 minutes. Then, check for any blockage of the air passage, if the air filter is dirty, and if the surrounding temperature is above 35°C. After addressing these issues, turn the power back on. If the message persists, set the FAN SPEED in the OPTION menu's SERVICE item to HIGH.
A
abigaildavidsonAug 28, 2025
What to do if my 3M Projector shows 'No input is detected'?
- P
  Pamela VelezAug 28, 2025
  If your 3M Projector shows 'No input is detected', confirm the signal input connection and the status of the signal source.
E
Erik ClarkSep 3, 2025
How to remove 'Reminder *** hrs passed after the last filter check' message from 3M X90w?
- J
  James DawsonSep 3, 2025
  To remove the 'Reminder *** hrs passed after the last filter check' message from your 3M Projector, immediately turn the power off. Clean or change the air filter. After cleaning or changing the air filter, reset the filter timer.