Why does my 3nStar Printer print unsteadily?
If your 3nStar Printer prints unsteadily, it could be due to: * The printer being in Hex Dump mode, so turn the printer off again and exit out of the dump mode. * The Serial line (RS-232) setting being incorrect, so reset the RS-232.
Why is RTC time incorrect when 3nStar Printer is restarted?
If the RTC time is incorrect when your 3nStar Printer is restarted, the battery on the motherboard is likely dead. Replace the battery on the motherboard.
General| Resolution | 203 DPI |
|---|---|
| Print Method | Direct Thermal |
| Print Speed | 90mm/sec |
| Interface | USB, Bluetooth |
| Print Technology | Thermal |
| Supported Barcode Types | UPC-A, UPC-E, EAN-13, EAN-8, CODE39, CODE128 |
Detailed technical specifications of the thermal transfer printer, including resolution and interfaces.
General specifications including printer measurement, weight, power, and environmental conditions.
Specifications for paper types, sizes, and winding for the printer.
Step-by-step guide on how to install the printer and connect it to a computer.
Detailed instructions for correctly installing the ribbon into the printer.
Instructions for loading and installing paper rolls or fanfold paper.
To Next Page
