System Requirements
www.3ware.com 3
Drive Requirements
Depending on the particular model, the 3ware RAID controller may be
connected to two, four, eight, twelve, sixteen, or twenty-four SATA drives
using the supplied interface cables.
Drives must meet SATA-1 (1.5 GB/s) or SATA-2 (3.0 Gb/s) standards.
A list of drives that have been tested is available at
http://www.3ware.com/products/compatibility_sata2.asp
Drives may be of any capacity or physical form factor.
The length of shielded and unshielded interface cables may not exceed 1M
(39”) for Serial ATA controllers.
Operating System
• 3ware RAID controllers may be used with:
• Windows 2000, Windows XP, Windows Server 2003, both 32-bit and 64-
bit x86
• Red Hat Linux, 32-bit and 64-bit x86
• SuSE Linux, 32-bit and 64-bit x86
• Fedora Core, 32-bit and 64-bit x86
• Other versions of Linux, 32-bit and 64-bit x86, using the open source
Linux 2.4 or 2.6 kernel driver
• FreeBSD, 32-bit and 64-bit x86
For the latest driver versions for all operating systems, see the current Release
Notes at http://www.3ware.com/support/.
Other Requirements
• Adequate air flow and cooling
• Adequate power supply for drives
• 3DM 2 (3ware Disk Manager) displays information in a browser. It
requires one of the following browsers:
• Internet Explorer 5.5 and later
• Mozilla Firefox 1.2 and later
• Netscape 7 and later
In addition:
• JavaScript must be enabled
• Cookies must be enabled
To Next Page
