21
20
Error Indication
If there is anything abnormal about the scooter, the warning indicator will flash, with the flashing
value E1-E6 displayed.
Errors Code Solutions
Communication
Fault
E1
Brake failure E2
Throttle Failure
Motor Fault
E3
E4
Controller failure E5
Overheated Motor E6
Please check whether the
brake is pressed.
Please check whether the
throttle is pressed.
Check whether the motor
and controller wire is
connected correctly.
Press and release the brake to reset the brake.
If it is open-circuit or short-
circuited, please replace the
connecting wire.
Replace the brake handle.
Replace the throttle.
Press and release the throttle to reset the throttle.
If it is open-circuit or short-
circuited, replace the connecting
wire.
If it is not connected correctly, please adjust and connect the motor and the
controller correctly.
If the motor temperature is too high, please wait for the motor to
cool to the appropriate working temperature.
If the motor temperature is normal, check whether the connecting
wire of the controller is short-circuited. If it is short-circuited,
please replace the connecting wire.
If the controller is damaged, please replace the controller.
Check whether the motor
temperature is too high.
Please check whether the taillight is on. If it is off, it means that the power supply is insufficient.
Please replace the controller or the LED display. If it is on, please check whether the connecting
wire between the controller and the LED display is open-circuit.
If not, please check whether the
connecting wire between the
brake and the LED display is
short-circuited or open-circuit.
If not, please check whether the
connecting wire between the
throttle and the LED display is
short-circuited or open-circuit.
If it is connected correctly, please disconnect the connecting wire
and measure whether the internal resistance between the
three-phase wires of the motor is within a reasonable range,
generally within 0.1Ω-1Ω. If it exceeds the range, the motor needs
to be replaced.
8 Indication Description
Automatic cruise indication:
Start Shut down
When automatic cruise is turned on, the
indicator will be on for a long time.
When automatic cruise is turned off,
turn off the indicator.
Headlamp status indication:
Start Shut down
When the headlight setting is turned on,
the indicator will be on for a long time.
Turn off the indicator when the headlight
setting is turned off.
Third gear indication:
First gear Second gear Third gear
The first gear is open The second gear is open The third gear is open
To Next Page
Loading...
