02
1. Installing the electrostatic sticker
Paste the electrostatic
sticker on the
recommended area on
the front windshield.
Press the sticker to
remove air bubbles out.
Avoid the edge of the windshield and select the flat
and smooth area for the installation.
Note: Keep windshield clean and dry without liquid
residue to prevent the sticker from losing adhesion and
dash cam from dropping.
4. Routing cable
Route the power cord
to the vehicle's power
outlet and connect to
power.
Start the car engine,
and the dash cam will
automatically turn on.
Note: Depending on the vehicle, the power outlet may be
located in a different position. The provided figure is for
reference only.
Installation
2. Installing the memory card
Insert the memory card into the card
slot with its contacts facing up.
3. Mounting the dash cam
Paste the dash cam onto the
electrostatic sticker.
5. Adjusting the camera angle
Bind the dash cam to the
70mai app following the
instructions in the user guide.
Adjust the camera angle
based on the image presented
in the dash cam's homepage.
To Next Page
Loading...
