3. Go to your Windows device’s Bluetooth setting, pair with [8Bitdo SF30 Pro] or [8Bitdo SN30
Pro]. LED will become solid when connection is successful.
4. Controller will auto reconnect to your Windows device with the press of START once it has
been paired
USB Connection: connect the controller to your Windows device via USB Cable after step 1.
macOS
1. Press and hold START+A for 1 second to power on the controller, LEDs 1,2,3 will start to
blink.
2. Press and hold PAIR for 3 seconds to enter pairing mode. LEDs will rotate from left to right.
3. Go to your macOS device’s Bluetooth setting, pair with [Wireless Controller]. LED will
become solid when connection is successful.
4. Controller will auto reconnect to your Windows device with the press of START once it has
been paired.
USB Connection: connect the controller to your macOS device via USB Cable after step 1.
Turbo function
1. Hold the button you would like to set turbo functionality to and then press the STAR button to
activate turbo functionality.
2. HOME LED will blink when turbo functionality has been applied successfully.
3. All buttons with Turbo functionality activated will cause the HOME LED to blink, showing
you that Turbo functionality is active on that button.
4. To deactivate turbo function, hold the button with turbo functionality activated press the
STAR button to deactivate turbo functionality. The HOME LED will no longer blink if you
have successfully disabled turbo functionality.
Analog sticks are not included.
This does not apply to Switch.
Battery
Status LED Indicator
Low battery mode POWER LED blinks
Battery charging POWER LED stays solid
Battery fully charged POWER LED turns off
·Built-in 480 mAh Li-on with 16 hours of play time.
·Rechargeable via its USB-C cable with 1 – 2 hour charging time.
To Next Page
Loading...
Need help?
General
