14
Maintenance
BAFFLE FILTERS
When bafe lters need replacing, exchange them with similar
bafe lters with stainless steel clips. Also replace bafe lters
that are damaged with punctures, bends, or broken frames.
- Turn off the range hood and disconnect the power.
- Replace with an equivalent bafe lter, then reconnect the
power.
REPLACING LIGHT BULBS
When light bulbs burn out, replace them with a 25 W or 35 W / JDR
16, GU10 twist and lock base light bulb.
□ Turn off the range hood, disconnect it from its power
source, and ensure that the lights are cool.
□ Turn the bulb (2) counter-clockwise and pull it out to
remove it.
□ Push in the new bulb (3) and turn it clockwise. Do not
release the bulb until you are sure the bulb has been
securely installed. Then reconnect the power.
□ If new bulbs do not operate, ensure that they are inserted
correctly.
DANGER: Turn off the power circuit breaker or the power
switch on the junction box before performing maintenance.
Touching circuitry inside the range hood while it is
energized will result in death or serious injury.
WARNING: Failure to replace worn out or damaged lters
will increase the risk of re.
WARNING: Light bulbs can become extremely hot when
turned on. Do not touch bulbs until they are switched off
and cooled. Touching hot bulbs could cause serious burns.
3
To Next Page
Loading...