At the end of your ride
Switch off the system with your E-Key.
Your range
Factors affecting range:
• Level of assistance
• Battery charge state
• Using the right gears for the corresponding speed
• Tyre inflation pressure
• Front wheel bearings and both brakes (tight bearings or dragging
brake shoes reduce the range)
• Rider weight (it takes more energy to accelerate a heavier per-
son)
• Your speed and local wind conditions (range is reduced when
riding fast against a high wind)
• Terrain (riding on soft surfaces or uphill requires more force)
• Frequent starting and stopping (full force from standstill requires
the most power from the battery)
Maximise your range
• Fully charge your battery before each ride.
• Regularly check the tyre pressure and pump up the tyres to a pres-
sure of 2.8 bar (front and rear wheels).
• Have your A2B serviced regularly to ensure that the wheel bearings
turn freely and that the brake shoes do not drag against the brake
disks.
• Keep the total weight as low as possible.
• Ride at low speeds.
• Use the energy saving mode as often as possible and assist the
motor by pedalling using your own strength.
• Keep the chain and derailleur lubricated with chain spray recom-
mended for bicycles.
To Next Page
Loading...
