7.0 Maintenance
Have your A2B checked by your
A2B specialist dealer at least once
a year. Observe Section 13 in this
respect. Maintenance schedule.
7.1 Wheels
The front and rear wheels should
be centred in the fork and frame.
Regularly check the wheels for
proper spoke tension and rim
alignment. DO NOT use your A2B
if it has broken or missing spokes.
The wheels should run evenly
and without wobbling laterally or
vertically.
7.2 Hub bearings
Regularly check the hub bearing
seat by lifting the wheel off the
ground and spinning it whilst trying
to move the rim from side to side
between the fork or frame. You
should not be able to determine
a side-to-side movement. If you
detect lateral movement in either
wheel, the hub bearings must be adjusted or replaced.
7.3 Wheel rims
The wheel rims should not have any
cracks, bulges or flat areas. Take your
A2B to your A2B specialist dealer as
necessary to have the wheels repaired
and/or adjusted.
7.4 Drive chain
Your A2B is equipped with a high
quality chain. This chain must be
cleaned periodically and lubricated
with a synthetic lubricant specifically
recommended for bicycles.
To Next Page
Loading...
