35
No power? Here are a few suggested solutions.
If they do not solve your problem, ask an A2B specialist dealer.
Problem
The A2B will not switch on.
A2B switches on but there is no motor
assistance (display lights up and charge
indicator shows charged battery).
Possible cause(s)
1. The battery is dead.
1. A brake lever is applied.
2. No power level has been pre-selected.
3. The controller did not wake up after
the switching on (note: the light does not
illuminate even though the light is switched
on).
4. The connector for the power supply to
the motor is unplugged.
Solution
Recharge the battery. See 5.2 and 5.3
Do not apply the brakes when starting
the A2B. Ensure that the brake levers are
aligned completely to the front.
Pre-select a power level (see 4.5).
Repeat the switching on procedure.
Should the controller still not wake up,
disconnect the battery from the connector
and reconnect the battery after waiting
3 seconds. Repeat the switching on
procedure.
Ensure that the connector to the motor is
fastened securely.
9.0 Troubleshooting
To Next Page
Loading...
