Aaeon EMB-B75B - System Agent (SA) Configuration

Chapter 3: BIOS setup
3-11
3.4.2 SystemAgent(SA)Conguration
GraphicsConguration
Allowsyoutocongurethegraphicssettings.
Primary Display [Auto]
Select which graphics device would be used as primary display.
Congurationoptions:[Auto][IGFX][PEG][PCI]
Internal Graphics [Auto]
CongureIGDsupportfordisplay.Congurationoptions:[Auto][Disabled][Enabled]
DVMT Pre-Allocated [64M]
Select DVMT 5.0 Pre-Allocated graphics memory size used by the Internal Graphics
Device.Congurationoptions:[32M,64M,96M~1024M]
DVMT Total Gfx Mem [MEM]
Select DVMT 5.0 total graphics memory size used by the Internal Graphics Device.
Congurationoptions:[128M][256M][MAX]
Primary IGFX Boot Display [VBIOS Default]
Select which video device will be activated during POST. This setting does not apply
if external graphics hardware is available. VGA support only available on the primary
display.
Congurationoptions:[VBIOSDefault][CRT][LVDS1][HDMI1][HDMI2]
Secondary IGFX Boot Display [LVDS1]
Asecondarydisplaywillappearbasedonyourselection.Congurationoptions:
[Disabled] [CRT] [LVDS1] [HDMI1] [HDMI2]
Select LCD Panel Type [1024x768, 18bit, 60Hz]
Select LCD panel type used by the Internal Graphics Device. Select the appropriate
resolution, bit rate, and refresh rate for your LCD panel.
LVDS Backlight Level [80%]
SelectbacklightbrightnessofLVDS.Congurationoptions:[100%~0%]
LVDS Backlight Type [Normal]
Selectbacklightcontroltype.Congurationoptions:[Normal][Inverted]
NBPCIeConguration
AllowsyoutoconguretheNBPCIExpresssettings.
PEG0 - Gen X [Auto]
CongurePEG0device.Congurationoptions:[Auto][Gen1][Gen2][Gen3]
Enable PEG [Enabled]
EnableordisblePEGsupport.Congurationoptions:[Disabled][Enabled][Auto]
Detect Non-Compliance Device [Disabled]
Detect non-compliant PCI Express hardware in PEG.
Congurationoptions:[Enabled][Disabled]