11
About Memory
The device automatically stores up to thirty blood pressure and pulse
measurements in memory. Data stored in memory are assigned a data number
in the order of the newest to the oldest. The oldest data displays as "n01". The M
symbol in the upper left corner of the display indicates that you are viewing
previous data stored in memory.
Recalling Data
1. When nothing is displayed, press and hold the
START button to display the data number.
The data number of the most recent
measurement and the data are displayed.
2. The data are automatically displayed in turn.
3. The display will shut off automatically after all
data is displayed.
Note: If you press the START button while
recalling data, the device starts
measurement.
Clearing Data
Remove the batteries to clear all data. Re-install them again.
If there is no data stored in memory, you will see two 0s displayed
vertically followed by a blinking "A00".
Press and hold
To Next Page
Loading...
