To Next PageTo Next Page
Need help?Do you have a question about the AAON WHA-012 and is the answer not in the manual?
General| Model Number | WHA-012 |
|---|---|
| Category | Heat Pump |
| Phase | 1 |
| Refrigerant | R-410A |
| Cooling Capacity | 12000 BTU/hr |
| Width | 24 inches |
Explains CAUTION/WARNING statements and general safety rules for operation.
Covers electrical hazards, unit handling, chemical use, and water freezing.
Details safe lifting, handling, and installation practices.
Warns against improper practices leading to failure or voided warranty.
Details checking for shipping damage, packaging, and nameplate verification.
Explains how reduced airflow affects cooling coils and compressor lubrication.
Covers mounting requirements, duct connection, and sealing.
Specifies p-trap installation, drain line pitch, and air breaks.
Emphasizes using drain pans to prevent water damage.
Provides table for required front, back, air intake, and bottom clearances.
Step-by-step guide for removing the blower assembly from the side.
Guidelines for safely lifting and moving the unit.
Details accessing components through the bottom panel.
Step-by-step guide for removing the blower assembly from the bottom.
Procedures for accessing and removing the blower motor and fan.
Discusses water piping for the heat exchanger and corrosion warnings.
Warns about chemical corrosion in open loop systems and warranty exclusions.
Explains damage caused by freezing water and warranty exclusions.
Warns about voltage imbalance effects and grounding requirements.
Guides on checking and adjusting refrigerant charge for sub-cooling and superheat.
Lists alarm conditions, LED diagnostic codes, and automatic reset logic.
Lists pre-startup checks for installing contractors.
