1
2
GETTING STARTED
ATTACHING CYLINDER
DETACHING CYLINDER
Remove the spill tray grid and then carefully lay the carbonator down on
the side with the lever upwards.
Unscrew the plastic sealing from the cylinder top. Carefully insert the gas
cylinder through the hole at the bottom. Don’t drop the cylinder into the
hole. When you feel that it reaches the bottom, begin screwing the cylinder
clockwise until it is fastened. Don’t screw too hard since this might break
the threads holding the gas cylinder in place.
When you need to replace the gas cylinder, lay the carbonator down on the
side with the lever pointing up and unscrew it counterclockwise and then
carefully pull it out of the compartment.
1
ATTACHING THE GAS CYLINDER
76
ENGLISH
To Next Page
Loading...
