Alarm
116 Aastra 632d
eud-1586/1.0 – R3.0 – 04.2013
Response times
You can set the following response times (hh:mm:ss):
Detection duration:
As soon as the phone detects an alarm situation, the Detection duration starts to run.
An alarm is only triggered when the detection duration has completely expired and
the alarm status has constantly occurred during this time. You can set a different dura-
tion for each alarm:
• The detection duration for man-down and no-movement alarm: min. 00:00:10 up
to max. 23:59:59.
• The detection duration for escape alarm: min. 00:00:05 up to max. 00:00:59.
Sensitivity:
For no-movement and escape alarm you can also set the Sensitivity (High, Medium,
Low) of the detection.
Alarm cancellation delay:
The Alarm cancellation delay indicates the pre-alarm’s duration as of when the alarm is
to trigger. You set the duration for all alarms together: min. 00:00:00 up to
max. 00:59:59.
Alarm confirmation time:
The Alarm confirmation time indicates how long the alarm shall ring as long as the
receipt is not acknowledged on the phone. You set the duration for all alarms
together: min. 00:00:00 up to max. 23:59:59.
Stopping a triggered pre-alarm
The man-down, no-movement and escape alarm has been triggered and you now
want to stop it.
You can stop the alarm on the phone as long as no alarm message has been sent to
the alarm system. Whether you can still stop the alarm thereafter depends on the
alarming concept set.
Cancel
No-movement, man-down and escape alarm was triggered:
Press the Cancel softkey or any key.
➔The pre-alarm on the phone is stopped.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 48 46
To Next Page
Loading...
