11Dialog 4106 Basic/Dialog 4147 Medium
Description
1 Program
Store frequently used numbers, see section “Speed Dialing” on
page 27.
2 Message Waiting / 2nd
a. A flashing light indicates a waiting message. See section
“Messages” on page 56.
b. Key for access to secondary key functions (these functions are
stated on the second line of the corresponding key).
3 Programmable keys
Eight keys for storing frequently used numbers. You can store two
numbers per key, see section “Speed Dialing” on page 27.
4Mute
Switch microphone on or off. See section “During Calls” on
page 36.
5 Loudspeaker on/off / Headset key
a. Switch loudspeaker on or off. See section “During Calls” on
page 36.
b. Activate headset. See section “Headset” on page 73.
6 Last number redial / Pause key
a. Redial last dialed number. See section “Last Number Redial” on
page 23.
b. Insert a pause if you have to wait for dial tone. See section “Wait
for dial tone” on page 21.
7 R-key
Used for example to make an inquiry, to transfer a call or to
establish a conference, see section “During Calls” on page 36.
Note: Sometimes it is necessary to change the flash time
for the R-key, see section “Flash time” on page 74.
8 Volume control
Adjust the volume.
9 Headset / Loudspeaker switch
a. In headset position, the Loudspeaker key activates a connected
headset. See section “Settings” on page 68.
b. In loudspeaker position, the Loudspeaker key activates the
loudspaker. See section “Settings” on page 68.
10 Prog On/Off switch
Enable or disable the Program key. See section “Settings” on
page 68.
To Next Page
Loading...
Need help?
General