Page 60 01/2007 AMT/PTD/PBX/0062/1/2EN
The following parameters can be configured using the OMM web service:
♦
♦
♦
♦
♦
Read-only Community
System Contact
Activate Trap Handling
Trap Community
Trap Host IP Address
The community names are used for both SNMPv1 and SNMPv2c.
The RFP needs an initial OMM connection to receive its SNMP configuration. In case of reset,
this configuration does not change. Changing the SNMP configuration forces all agents to be
reconfigured.
The agent does not support MIB-II write access, SNMPv2-MIB read/write access, NET-SNMP-
MIB read/write access, NET-SNMP-AGENT-MIB read/write access and SNMPv3.
4.5.3.4 BACKUP
The web service interface is used to save a copy of the current configuration on the local host
(host where the browser application is executed) as well as to restore an older configuration.
Restoring a previously saved configuration will lead to a reset of the OMM to take effect.
after configuring the installation, it is highly advisable to back up the OMM data. IMPORTANT :
To Next Page
Loading...