Page 80 01/2007 AMT/PTD/PBX/0062/1/2EN
Menu
Phonebook
RFPI 10FFF21 02
FE PP: FP:
-dBm 50 57 50
RPN 02 01 00
PARK: 1F-10-FF-F0-21 RFP ID: 02*
RFP ID: 02*
*The ID of RFP with which the PP is currently associated.
Frame error
Field strength
RFP ID
In this example, the PP is currently connected to RFP number 02. RFP 01 and 00 are also
visible. The number 10FFF221 02 on the upper right side refers to the PARK 1F-10-F2-21 of the
IP DECT system and to the RFP to which the phone is currently connected.
6.1.2.2 AUTO CALL TEST MODE
In this mode, the phone will call a predefined number cyclically. You can use this feature to
generate traffic for test purposes. This mode is also active if the phone is on the charger.
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
Using the interactive keys, successively select “Menu/Local mode and press OK.
Select “System” (just to highlight it).
Enter the key sequence: ***76#
Select Auto Call Test
Press OK.
Enter the phone number to dial.
Press OK.
Enter a number of seconds between two calls.
Press OK.
Enter a number of seconds during which a call must be active.
Press OK. The test will be started automatically.
To stop the test, switch the phone off and on again.
6.1.2.3 AUTO ANSWER TEST MODE
In this mode the phone will answer incoming calls automatically. You can use this feature
together this phones in the “auto call test mode” for test purposes. This mode is also active if the
phone is on the charger.
To Next Page
Loading...