Aastra Vista 150 - Call Handling Procedures; SuperFlash Call Switching; Using the Hold Feature; Volume Controls

6
Vista User Guide
A person at either extension can simply press the ¬ button to automatically
switch to and speak with the new caller as shown in the diagrams below.
Calls will not be disconnected when you press ¬ . If you wish to return to your
first caller press ¬ again. The Vista 150 and one other Aastra SuperFlash™
compatible telephone extension may switch between the two callers each time you press
¬ . Once you have switched to one caller by pressing ¬ , you must wait
three seconds before you can switch back to the previous caller.
To end a call with either Caller One or Caller Two, you must press ¬ before the
caller hangs up the line in order for the proper caller information to be displayed.
Note : Caller information for the first call will only be displayed on the original telephone
that answered.
Hold - Continuing a call on another telephone
If you want to place your call on hold or continue your conversation at another extension,
press ˙ and hang up the receiver. The hold feature keeps the caller on the line until
you pick up the receiver or an extension telephone.
Note: If you receive a Visual Call Waiting call while a call is on hold, Call Waiting
information will not be displayed.
Receiver volume
While you are on the telephone, you can press the left or right side of the volume bar
for soft or loud receiver volume.
Ringer volume
Press the left or right side of the volume bar for soft or loud ringer volume. If
you don’t want to be disturbed you can turn the ringer OFF by pressing the left side of the
volume bar without lifting the receiver. Continue pressing the left side of the
4
Either telephone can press
to speak with Caller Two.
5
Both telephones speak with Caller Two
and see displayed information.
Extension
Extension in use
CALLER TWO
Extension in use
CALLER TWO
6
Either telephone may press
again to switch back to Caller One.
kk
kk
ll
ll
kk
kk
ll
ll
kk
kk
ll
ll