Need help?Do you have a question about the AAVIK U-180 and is the answer not in the manual?
Follow instructions for safe operation, cleaning, placement, and servicing.
Key safety warnings regarding liquids, environment, power supply, and detecting faults.
Shows selected source, volume, and digital input format (PCM, MQA, DSD).
Places the amplifier in standby or switches it on. Outputs are muted during startup.
Mutes outputs, pairs remote control, and allows remote pairing removal.
Selects source, activates input selection, and accesses the menu.
Adjusts volume, source, or other settings using the rotary knob.
Accepts spade connectors and 4mm banana plugs for speaker cables.
Provides pre-amplifier outputs for sub-woofers, power amps, or headphone amps.
Five single-ended RCA line inputs with adjustable gain for signal sources.
Two electrical S/P-DIF inputs supporting PCM, MQA, and DSD64 via DoP.
Two optical S/P-DIF inputs supporting PCM, MQA, and DSD64 via DoP.
One fully isolated UAC 2 asynchronous USB input supporting up to DSD128.
Switches between full power off and standby mode; low power consumption in standby.
Accepts mains voltages from 100-240VAC; uses IEC 60320-C13 connector.
For use by qualified service personnel only.
Provides a 12VDC trigger output for powering other equipment.
Sets the gain for selected inputs, influencing the level between input and pre out.
Adjusts the left/right audio balance in 1dB steps.
Configures whether pre-out connectors are muted with speakers when amplifier is muted.
Adjusts the display brightness through four selectable levels.
Sets the display to switch off automatically after 1-5 seconds.
Displays the current operating temperature of the power amplifier.
Shows the current firmware version installed on the amplifier.
Sets a specific input for fixed volume, or disables the function for regular inputs.
Defines the fixed volume level for the home theatre bypass input.
Details gain, maximum input voltage, and impedance for line input channels.
Lists available digital input types (BNC, TOSLINK, USB) and supported formats.
Specifies maximum output voltage, distortion, and output impedance for pre-out.
States the number of steps for volume control.
Details power output at different impedances, distortion, and IMD figures.
Lists specifications for Tesla Coils, Dither circuitry, and Resonance Coils.
Specifies power usage in standby and idle modes.
Provides the physical dimensions of the amplifier.
Indicates the weight of the amplifier.
To Next Page
General
