Need help?Do you have a question about the AAVIK U-150 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Output power | 150 W |
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | >110dB (A-weighted) |
| Input Impedance | 10kΩ |
| Damping Factor | > 200 |
| Gain | 32dB |
| Power consumption, Standby | <0.5W |
| Dimensions | 430 x 120 x 350 mm |
| Weight | 15 kg |
| Total Harmonic Distortion (THD) | <0.005% (1W/8Ω) |
| Total Harmonic Distortion | < 0.1% |
| THD + N | < 0.1% |
| Inputs | RCA, XLR |
Details output, input, and physical specifications of the amplifier.
Provides essential safety guidelines, warnings, and precautions for amplifier use.
Illustrates the physical arrangement of rear panel connectors.
Explains power inlet, on/off, line/phono inputs, pre out, and speaker terminals.
Details USB, TOSLINK, BNC digital inputs, and RS-232 port.
Explains how to adjust input-specific and common settings via the menu.
Illustrates the physical arrangement of front panel controls and indicators.
Explains source indicators and the multi-function mute button.
Details individual gain, cartridge loading, and balance settings using the mute button.
Explains standby mode and source selection via navigation button.
Describes the volume knob, volume display, and mute indicator.
Details the functions of each button on the remote control.
Explains how to pair the remote and perform a factory reset.
To Next Page
