29
Menu-> SETTINGS ->CI Menu
1.Push the smart card in the CI module. The Golden Chip must show up. And the
smart card standard must correspond to CI module. Then insert the CI Module to
the CI slot.
2.You can read the detail information about the smart card and CI module after it
initialized OK.
3. The Pay-TV which correspond to CI module standard can be decoded.
6.7 Connecting to the
LAN
6.7.1 IP Setting
1. Connect one end of the
Ethernet cable to the product and the
other end to the LAN router.
2. Menu-> SETTINGS ->IP
Setting
If the Ethernet cable is connected fine,
it will display “Connect”. In this menu, you can set IP address manually, also you can
get IP address automatically.
" RED: Get IP address
automatically.
" GREEN: Test the network if
connect correctly.
6.7.2 Connecting to the Wi-Fi
(Wireless LAN)
1. Plug in the wireless USB dongle
to the USB port.
2. Enter Menu->SETTINGS->Wireless Setting->Search Access Pointer.
To Next Page
Loading...
