INITIALISATION PROCEDURE
The soft top must be re-initialised after
disconnecting the battery or if the rele-
vant protection fuse is blown.
Proceed as follows:
❒
before carrying our any operation,
make sure the motor is running during
the whole initialisation procedure;
❒
keep the opening button pressed
until the soft top is completely open;
❒
when the soft top is completely open,
keep the button pressed for at least 2
seconds;
❒
keep the closing button pressed until
the soft top is completely closed;
❒
when the soft top is completely
closed, keep the button pressed for at
least 2 seconds.
When the procedure is terminated, the
soft top will automatically carry out a com-
plete opening and closing cycle (up to 25
cm from the completely closed position)
to inform the driver that correct opera-
tion has been restored.
WIND STOP
The Wind Stop fig. 9 is designed to
improve driving comfort, by reducing air
turbulence in the passenger compart-
ment when travelling with the top down.
To use it:
❒
Release the backrest of the rear seat
(single or split).
❒
Attach the Wind Stop by inserting the
central part inside the rear screen guard,
with the concave part in the direction of
the passenger, as shown in the figure.
❒
Correctly re-position the backrest;
the Wind Stop is locked between the
seat and parcel shelf.
fig. 9
F0S0334m
With the Wind Stop fitted, it is still pos-
sible to move the electric hood.
When not in use, the Wind Stop should
be stored in the luggage compartment
without loading excessive weight on top
of it; do not bend.
FRONT SPOILER
The car is provided with a front spoiler
which can be raised to improve aerody-
namic comfort inside the passenger
compartment.
To raise the spoiler, release the catch
using the slider A-fig. 10 moving it to
position b, as shown.
Be careful not to move the slider A-
fig. 10 from position b to position a
with the spoiler raised.
fig. 10
F0S0308m
8
603_97_890 ABARTH 500C GB 1ed 31-05-2010 10:54 Pagina 8
To Next Page
Loading...
Need help?
General
