ABB 630 series - Page 19

Function name Signal type Signal name Description
CMMXU.1.I_ANGL_C Phase C angle, instantaneous
value
Sequence current
measurements (CSMSQI)
Analog inputs CSMSQI.1.I1_DB Positive sequence current
amplitude, reported value
CSMSQI.1.I1_ANGL_INST Positive sequence current
angle, instantaneous value
CSMSQI.1.I2_DB Negative sequence current
amplitude, reported value
CSMSQI.1.I2_ANGL_INST Negative sequence current
angle, instantaneous value
Event counters (CNTGGIO) Counters CNTGGIO.1.VALUE1 Output of counter 1
CNTGGIO.1.VALUE2 Output of counter 2
CNTGGIO.1.VALUE3 Output of counter 3
CNTGGIO.1.VALUE4 Output of counter 4
CNTGGIO.1.VALUE5 Output of counter 5
CNTGGIO.1.VALUE6 Output of counter 6
Power monitoring function with
P, Q, S, power factor
(PWRMMXU)
Analog inputs PWRMMXU.1.P_DB Active Power magnitude of
deadband value
PWRMMXU.1.Q_DB Reactive Power magnitude of
deadband value
PWRMMXU.1.S_DB Apparent Power magnitude of
deadband value
PWRMMXU.1.F_DB System frequency magnitude of
deadband value
PWRMMXU.1.PF_DB Power Factor magnitude of
deadband value
Binary inputs PWRMMXU.1.ILAG Current is lagging voltage
PWRMMXU.1.ILEAD Current is leading voltage
Disturbance report (DRRDRE) Binary inputs DRRDRE.1.RECMADE Disturbance recording made
DRRDRE.1.CLEARED All disturbances in the
disturbance report cleared
DRRDRE.1.DRPOFF Disturbance report function
turned off
DRRDRE.1.Fault number Disturbance fault number
DRRDRE.1.MEMUSED More than 80% of memory used
DRRDRE.RECSTART Disturbance recording started
DNP small disturbance report
(DNPFREC)
Analog inputs DNPFREC.1.Active setting
group
Active setting group
DNPFREC.1.Fault Freq Fault Freq
DNPFREC.1.Fault Location Fault Location
DNPFREC.1.Fault Number Fault Number
DNPFREC.1.Fault Type Fault Type
DNPFREC.1.No of faults in IED No of faults in IED
DNPFREC.1.Trig Signal Id Trig Signal Id
Table continues on next page
1MRS756791 A Section 2
DNP3 data mappings
630 series 13
Point List Manual