ABB 630 series - Page 35

Function name Signal type Signal name Description
T1PTTR.1.BLK_CLOSE Thermal overload indicator. To
inhibit reclose
T1PTTR.1.ALARM Alarm signal
Negative-sequence overvoltage
(NSPTOV )
Binary inputs NSPTOV.START Start signal for Negative
Sequence Overvoltage logic
NSPTOV.OPERATE Operate signal for Negative
Sequence Overvoltage logic
Three-phase overvoltage
(PHPTOV)
Binary inputs PHPTOV.1.ST_A Start signal, phase 1
PHPTOV.1.ST_B Start signal, phase 2
PHPTOV.1.ST_C Start signal, phase 3
PHPTOV.1.START Start signal, combined
PHPTOV.1.OPR_A Operate signal, phase 1
PHPTOV.1.OPR_B Operate signal, phase 2
PHPTOV.1.OPR_C Operate signal, phase 3
PHPTOV.1.OPERATE Operate signal, combined
Three-phase undervoltage
(PHPTUV)
Binary inputs PHPTUV.1.ST_A Start signal, phase 1
PHPTUV.1.ST_B Start signal, phase 2
PHPTUV.1.ST_C Start signal, phase 3
PHPTUV.1.START Start signal, combined
PHPTUV.1.OPR_A Operate signal, phase 1
PHPTUV.1.OPR_B Operate signal, phase 2
PHPTUV.1.OPR_C Operate signal, phase 3
PHPTUV.1.OPERATE Operate signal, combined
Positive-sequence overvoltage
(PSPTOV)
Binary inputs PSPTOV.1.START Start signal for Positive
Sequence Overvoltage logic
PSPTOV.1.OPERATE Operate signal for Positive
Sequence Overvoltage logic
Positive-sequence
undervoltage (PSPTUV)
Binary inputs PSPTUV.1.START Start signal for Positive
Sequence Undervoltage logic
PSPTUV.1.OPERATE Operate signal for Positive
Sequence Undervoltage
protection
Three phase directional
overcurrent, low stage
(DPHLPDOC)
Binary inputs DPHLPDOC.1.START Started signal
DPHLPDOC.1.OPERATE Operated
DPHLPDOC.1.FAULT_DIR Detected fault direction, general
DPHLPDOC.1.ST_A Started phase A
DPHLPDOC.1.ST_B Started phase B
DPHLPDOC.1.ST_C Started phase C
DPHLPDOC.1.OPR_A Operated phase A
DPHLPDOC.1.OPR_B Operated phase B
Table continues on next page
1MRS756791 A Section 2
DNP3 data mappings
630 series 29
Point List Manual