ABB 630 series - Page 39

Function name Signal type Signal name Description
LSHDPFRQ.1.OPR_FRG Operate signal for high df/dt
LSHDPFRQ.1.OPERATE Operation of load shedding
Circuit breaker (DAXCBR) Binary inputs DAXCBR.1.UPD_BLKD The update of position
indication is blocked
DAXCBR.1.CLOSEPOS Apparatus closed position
DAXCBR.1.OPENPOS Apparatus open position
DAXCBR.1.OP_BLKD Indication that the function is
blocked for open commands
DAXCBR.1.CL_BLKD Indication that the function is
blocked for close commands
DAXCBR.1.UPD_BLKD The update of position
indication is blocked
DAXCBR.1.POSITION Apparatus position indication
Counters DAXCBR.1.CNT_VAL The value of the operation
counter
Autorecloser (DARREC) Analog inputs DARREC.1.PROT_DISA A word type signal for disabling
protection functions
DARREC.1.SHOT_PTR Shot pointer value
Binary inputs DARREC.1.OPEN_CB Open command for circuit
breaker
DARREC.1.CLOSE_CB Close (reclose) command for
circuit breaker
DARREC.1.CMD_WAIT Wait for master command
DARREC.1.INPRO Reclosing shot in progress,
activated during dead time
DARREC.1.LOCKED Signal indicating that AR is
locked out
DARREC.1.PROT_CRD A signal for coordination
between the AR and the
protection
DARREC.1.UNSUC_RECL Indicates an unsuccessful
reclosing sequence
DARREC.1.FRQ_OPR_AL Frequent operation counter
alarm
DARREC.1.AR_ON Autoreclosing allowed
DARREC.1.READY Indicates that the AR is ready
for a new sequence
DARREC.1.ACTIVE Reclosing sequence is in
progress
DARREC.1.INPRO_1 Reclosing shot in progress,
shot 1
DARREC.1.INPRO_2 Reclosing shot in progress,
shot 2
DARREC.1.INPRO_3 Reclosing shot in progress,
shot 3
DARREC.1.INPRO_4 Reclosing shot in progress,
shot 4
Table continues on next page
1MRS756791 A Section 2
DNP3 data mappings
630 series 33
Point List Manual