Function name Signal type Signal name Description
DARREC.1.INPRO_5 Reclosing shot in progress,
shot 5
DARREC.1.DISCR_INPRO Signal indicating that
discrimination time is inprogress
DARREC.1.CUTOUT_INPRO Signal indicating that cut-out
time is in progress
DARREC.1.UNSUC_CB Indicates an unsuccessful CB
closing
DARREC.1.MAN_CB_CL Indicates CB manual closing
during reclosing sequence
DARREC.1.SOTF Switch-onto-fault
Counters DARREC.1.FRQ_OPR_CNT Frequent operation counter
DARREC.1.CNT_SHOT1 Resetable operation counter,
shot 1
DARREC.1.CNT_SHOT2 Resetable operation counter,
shot 2
DARREC.1.CNT_SHOT3 Resetable operation counter,
shot 3
DARREC.1.CNT_SHOT4 Resetable operation counter,
shot 4
DARREC.1.CNT_SHOT5 Resetable operation counter,
shot 5
DARREC.1.COUNTER Resetable operation counter, all
shots
Synchrocheck (SYNCRSYN) Analog inputs SYNCRSYN.1.U_DIFF_MEAS Calculated difference in voltage
SYNCRSYN.1.FR_DIFF_MEAS Calculated difference in
frequency
SYNCRSYN.1.PH_DIFF_MEAS Calculated difference of phase
angle
Binary inputs SYNCRSYN.1.AUTO_REL Automatic release
SYNCRSYN.1.AU_ENERG_OK Automatic energizing check OK
SYNCRSYN.1.MAN_REL Manual release
SYNCRSYN.
1.MAN_ENERG_OK
Manual energizing check OK
SYNCRSYN.1.SYN_OK Synchronizing OK output
SYNCRSYN.1.SYN_INPRO Synchronizing in progress
SYNCRSYN.1.SYN_FAIL Synchronizing failed
SYNCRSYN.1.B1_SEL Bus1 selected
SYNCRSYN.1.B2_SEL Bus2 selected
SYNCRSYN.1.LN1_SEL Line1 selected
SYNCRSYN.1.LN2_SEL Line2 selected
Bay control (QCCBAY) Binary inputs QCCBAY.1.UPD_BLKD Update of position is blocked
QCCBAY.1.CMD_BLKD Function is blocked for
commands
QCCBAY.1.LOC Local operation allowed
Table continues on next page
Section 2 1MRS756791 A
DNP3 data mappings
34 630 series
Point List Manual
To Next Page
Loading...
