DNP3 device profile document
Count > 1 ○ Never ○ Always ● Sometimes ○ Configurable
Pulse on ○ Never ○ Always ● Sometimes ○ Configurable
Pulse off ○ Never ○ Always ● Sometimes ○ Configurable
Latch on ○ Never ○ Always ● Sometimes ○ Configurable
Latch off ○ Never ○ Always ● Sometimes ○ Configurable
Queue ● Never ○ Always ○ Sometimes ○ Configurable
Clear queue ● Never ○ Always ○ Sometimes ○ Configurable
Explanation of 'Sometimes' above: Supported binary output control operations depend on the type of point. Please consult the binary
output point list description.
Reports binary input change events when no specific variation
requested:
Reports time-tagged binary input change events when no specific
variation requested:
○ Never ○ Never
○ Only when time-tagged ○ Binary input change with time
○ Only non-time-tagged ○ Binary input change with relative time
● Configurable to send one or the other
(Obj2DefVar on DNP3Master)
● Configurable (Obj2DefVar on DNP3Master)
Sends unsolicited responses: Sends static data in unsolicited responses:
○ Never ● Never
● Configurable (UREnable on
DNP3Master)
○ When device restarts
○ Only certain objects ○ When status flags change
○ Sometimes (attach explanation)
● ENABLE/DISABLE UNSOLICITED
function codes supported
No other options are permitted.
Default counter object/variation: Counters roll over at:
○ No counters reported ○ No counters reported
● Configurable (obj20DefVar and
obj22DefVar in DNP3Master)
○ Configurable (attach explanation)
○ Default object
Default variation:
○ 16 bits
○ Point-by-point list attached ● 32 bits
○ Other value: _______
○ Point-by-point list attached
Sends multi-fragment responses:
○ Yes
○ No
● Configurable (ApplMultFrgRes on DNP3Master)
Deadbanding is not performed in the DNP protocol stack. Any deadbanding is a property of the IED’s underlying data, and is configured
through the IED configuration tools.
● = Selected,○ = Not selected
1MRS756791 A Section 3
DNP3 protocol implementation
630 series 43
Point List Manual
To Next Page
Loading...
