ABB ACS310 - Page 24

24 Start-up and control with I/O
Select the application macro according to which the
control cables are connected.
Continue with the application set-up. After
completing a set-up task, the Start-up assistant
suggests the next one.
 Press (when is highlighted) to
continue with the suggested task.
 Press key to highlight and then press
to move to the following task without doing the
suggested task.
 Press to stop the Start-up assistant.
DIRECTION OF THE MOTOR ROTATION
Check the direction of the motor rotation.
 If the drive is in remote control (REM shown on the
status line), switch to local control by pressing .
 If you are not in the Output mode, press
repeatedly until you get there.
 Increase the frequency reference from zero to a
small value with key .
 Press to start the motor.
 Check that the actual direction of the motor is the
same as indicated on the display ( means
forward and reverse).
 Press to stop the motor.
To change the direction of the motor rotation:
 If parameter 9914 PHASE INVERSION is not
visible, first set parameter 1611 PARAMETER
VIEW to 3 (LONG VIEW).
 Invert the phases by changing the value of
parameter 9914 to the opposite, ie from 0 (NO) to
1 (YES), or vice versa.
 Verify your work by applying input power and
repeating the check as described above.
 Set parameter 1611 back to 2 (SHORT VIEW).
9902 APPLIC MACRO
CANCEL SAVE
00:00
PAR EDIT
[1]
ABB STANDARD
REM
OK
Continue
Skip
OK
EXIT
Do you want to
continue with
EXT1 reference setup?
Continue
Skip
EXIT OK
00:00
REM CHOICE
LOC
REM
EXIT
DIR
MENU
00:00
LOC xx.xHz
xx x Hz.
x x A.
xx x %.
forward
direction
reverse
direction
1611 PARAMETER VIEW
CANCEL
SAVE
00:00
PAR EDIT
[3]
LONG VIEW
REM
9914 PHASE INVERSION
CANCEL SAVE
00:00
REM
[1]
YES
PAR EDIT