ABB ACS310 - Install the drive

32 Actual signals and parameters in the short view
ENGLISH British English 0
ENGLISH (AM) American English 1
DEUTSCH German 2
ITALIANO Italian 3
ESPAÑOL Spanish 4
PORTUGUES Portuguese 5
NEDERLANDS Dutch 6
FRANÇAIS French 7
DANSK Danish 8
SUOMI Finnish 9
SVENSKA Swedish 10
RUSSKI Russian 11
POLSKI Polish 12
TÜRKÇE Turkish 13
CZECH Czech 14
MAGYAR Hungarian 15
9902 APPLIC
MACRO
Selects the application macro. See chapter Application
macros in ACS310 Users Manual (3AUA0000044201
[English]).
ABB
STANDA
RD
ABB
STANDARD
Standard macro for constant speed applications 1
3-WIRE 3-wire macro for constant speed applications 2
ALTERNATE Alternate macro for start forward and start reverse
applications
3
MOTOR POT Motor potentiometer macro for digital signal speed control
applications
4
HAND/AUTO Hand/Auto macro to be used when two control devices are
connected to the drive:
 Device 1 communicates through the interface defined by
external control location EXT1.
 Device 2 communicates through the interface defined by
external control location EXT2.
EXT1 or EXT2 is active at a time. Switching between
EXT1/2 through digital input.
5
PID CONTROL PID control. For applications in which the drive controls a
process value, eg pressure control by the drive running the
pressure boost pump. Measured pressure and the pressure
reference are connected to the drive.
6
PFC
CONTROL
PFC (Pump and fan control) macro for pump alternation
applications
7
SPFC
CONTROL
SPFC (Soft pump and fan control) macro for pump
alternation applications where lower pressure peaks are
desirable when a new auxiliary motor is started.
15
Parameters in the short parameter view
No. Name/Value Description Def/FbEq