ABB ACS880-17 - Parameter Settings

Markings
CE mark
Product complies with the applicable European Union legislation. For fulfilling the EMC requirements,
see EMC Compliance (IEC/EN 61800-3:2004 + A2012).
UL listed mark for USA and Canada
Product has been tested and evaluated against the relevant North American standards by the Un-
derwriters Laboratories.
• Cabinet-installed multidrives: The drive with the option +C129 is UL listed. Valid with rated voltages
up to 600 V.
• Multidrive modules: The multidrive modules are UL listed as standard. The approvals are valid
with rated voltages up to 600 V.
CSA certification mark for USA and Canada
Product has been tested and evaluated against the relevant North American standards by
the CSA Group.
• Cabinet-installed multidrives: Product with option +C134 is CSA certified. Valid with rated voltages
up to 600 V.
• Multidrive modules: Product is CSA certified as standard. Valid with rated voltages up to 600 V.
EAC (Eurasian Conformity) mark
Product complies with the technical regulations of the Eurasian Customs Union. EAC mark is required
in Russia, Belarus and Kazakhstan.
RCM mark
Product complies with Australian and New Zealand requirements specific to EMC, telecommunica-
tions and electrical safety. For fulfilling the EMC requirements, see section EMC Compliance
(IEC/EN 61800-3:2004).
Electronic Information Products (EIP) green mark

The product complies with the People’s Republic of China Electronic Industry Standard (SJ/T 11364-
2014). The product does not contain toxic and hazardous substances or elements above the max-
imum concentration values, and it is an environmentally-friendly product which can be recycled.
TÜV Nord Safety Approved mark (functional safety)
Product contains Safe Torque Off and possibly other (optional) safety functions which are certified
by TÜV Nord according to the relevant functional safety standards. Applicable to drives and inverters;
not applicable to supply, brake or DC/DC converter units or modules.
WEEE mark
At the end of life the product should enter the recycling system at an appropriate collection point
and not placed in the normal waste stream.
Standards and markings 43