ABB ACS880 P940 Series - Installing the drive module shelves and connecting the cables

Installing the drive module shelves and connecting the
cables
￭ ACS880-01 frames R1 and R2
1. Attach the mechanical support shelf for the power cables to the drive module.
1
2. Connect the twisted shields of the power cables to the grounding terminals.
3. Connect the phase conductors of the input cable to the L1, L2 and L3 terminals and the
phase conductors of the motor cable to the T1/U, T2/V and T3/W terminals. Connect
the brake resistor conductors (if present) to the R+ and R- terminals. Tighten the screws
to the torque given in the figure below.
2
2
3
3
GroundingL1, L2, L3, T1/U, T2/V, T3/W, R-, R+/UDC+, UDC
1.8 N·m0.6 N·m
Electrical installation 37
11