Instruction IN/ANAINST/032-EN Rev. B
Endura AZ20 series probe
Combustion oxygen monitor
Installing large surface area filter
Kit reference: AZ200 737
Measurement made easy
1Introduction
This publication details fitting of a large surface area filter
to the AZ20 probe.
These procedures must be carried out by suitably trained
personnel and in accordance with the information given.
2 Tools / Items required
— M4 open-ended spanner
— 3 mm A/F hexagon wrench
— Solvent (lighter fluid / petroleum ether) or alcohol
(surgical spirits)
— Non-metallic pan scouring pad
— Scalpel / Small sharp blade
— Small flat-bladed screwdriver
— Transmitter Instruction manual IM/AZ20E-EN
— Probe Instruction manual IM/AZ20P-EN
— Maintenance guide IM/AZ20M-EN
To Next Page
Need help?
General
