EasyManua.ls Logo

ABB HD4/R - 5.7.5 General specifications of fixed circuit-breakers with rh lateral operating mechanisms for ABB UniSec switchgear (12 - 17.5 - 24 kV)

ABB HD4/R
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14/28 - 647021/002 - M5179 - 2002/06/10 it-en
7.5. Installation of removable circuit-breaker
The removable circuit-breakers are destined for use in
UniSwitch or UniAir switchboards. Special assembly opera-
tions are not usually necessary.
In any case, consult the documentation relative to the switch-
board.
7.6. Power circuit connections
7.6.1. General warnings
Check that the circuit-breaker terminals are clean and have
not been damaged by any shocks received during transport
or storage.
Select the conductor cross-section according to the service
and short-circuit current of the installation.
Provide suitable support insulators near the fixed circuit-
breaker terminals or the monoblocs of the cubicles, sized
according to the electrodynamic stresses caused by the
short-circuit current of the installation.
The circuit-breaker terminals are always silver-
plated. To clean them, only use dry rags, soaked in
a suitable solvent if necessary.
N.B. Never use a file or emery cloth!
7.5. Installazione interruttore rimovibile
Gli interruttori rimovibili sono destinati all'impiego in quadri
UniSwitch o UniAir. Normalmente non sono richieste opera-
zioni di montaggio particolari.
Consultare comunque la documentazione relativa al quadro.
7.6. Connessioni del circuito di potenza
7.6.1. Avvertenze generali
Controllare che i terminali dell’interruttore siano puliti ed
esenti da qualsiasi deformazione provocata da urti ricevuti
durante il trasporto o durante la permanenza a magazzino.
Scegliere la sezione dei conduttori in base alla corrente di
esercizio e alla corrente di corto circuito dell’impianto.
Predisporre appositi isolatori di supporto, in prossimità dei
terminali dell’interruttore fisso o dei monoblocchi degli scom-
parti, dimensionati in base agli sforzi elettrodinamici deri-
vanti dalla corrente di corto circuito dell’impianto.
I terminali dell’interruttore sono sempre argentati;
per la loro pulizia utilizzare esclusivamente stracci
asciutti, eventualmente imbevuti in adatto solvente.
N.B. Non utilizzare lima o tela smeriglio!
Fig. 7
! !

Other manuals for ABB HD4/R

Related product manuals