To Next PageTo Next PageWhy is my ABB Industrial Equipment experiencing a sluggish start-up?
A sluggish start-up in ABB Industrial Equipment can occur due to several reasons. It might be caused by a contaminated turbocharger, in which case you should clean it. Alternatively, it could be due to a damaged bearing, requiring you to contact an ABB Turbocharging Service Station. Other possible causes are a rubbing rotor or a foreign object in the turbocharger.
Is rubbing of rotating parts in ABB HT845102 Industrial Equipment a problem?
Rubbing of rotating parts in ABB Industrial Equipment can be normal behavior and not a malfunction. However, if there is any doubt about the extent of rubbing, then an ABB Turbocharging Service Station must be contacted.
What to do if ABB HT845102 Industrial Equipment has vibration?
If your ABB Industrial Equipment is vibrating, it could be due to rotor unbalance, in which case you should contact an ABB Turbocharging Service Station. Other potential causes include a damaged turbine or compressor, or a damaged bearing.
How to fix sluggish start-up of ABB Battery Charger?
A sluggish start-up in your ABB Battery Charger can be caused by a contaminated turbocharger, in which case you should clean it. Alternatively, it might be due to a damaged bearing, which requires you to contact an ABB Turbocharging Service Station.
What to do if rotating parts of ABB Industrial Equipment are rubbing?
Rubbing in ABB Industrial Equipment might be normal. If you have any doubts about the extent of rubbing, contact an ABB Turbocharging Service Station for a dimension check.
Why is the lubricating oil pressure too low in my ABB Battery Charger?
If the lubricating oil pressure is too low in your ABB Battery Charger, it could be due to several reasons. The oil filter might be heavily contaminated, which means it should be cleaned. Another possibility is a defective oil pump in the lubricating system, which needs to be checked or replaced. The manometer display could be wrong, requiring replacement of the manometer. Alternatively, the rotor axial clearance might be too large, which requires contacting an ABB Turbocharging Service Station.
How to fix a sluggish start-up in my ABB Battery Charger?
To address a sluggish start-up in your ABB Battery Charger, consider that it may be caused by a contaminated turbocharger, which needs to be cleaned.
Why is my ABB Battery Charger making noises during run-down?
Noises during run-down in your ABB Battery Charger can occur if the turbocharger is contaminated, requiring cleaning.
What causes low charge air pressure in an ABB Battery Charger?
If the charge air pressure is too low in your ABB Battery Charger, it could be due to a leaking air receiver or gas piping between the engine and the turbine, both of which require repairs. Additionally, a poorly adjusted injection system can cause this issue and needs to be corrected. A poorly adjusted valve control can also lead to low charge air pressure.
What to do if ABB HT845102 Industrial Equipment has rubbing of rotating parts?
If you suspect rubbing of rotating parts in your ABB Industrial Equipment, and you're unsure about the extent of the rubbing, it's best to contact an ABB Turbocharging Service Station. They can perform a dimension check to assess the situation.
General| ABB Type Designation | HT845102 |
|---|---|
| Rated Operational Voltage | 1000 V |
| Sub-Function | Disconnect |
| Type | Disconnect |
| Rated Voltage | 1000 V |
