ABB REB500 - Page 14

14000051-IEC18000623-1-en.vsdx
IEC18000623 V1 EN-US
Figure 1: Dialog box for configuring the communication
If Common Link Layer Address of the SCS Configuration is selected:
The link address can be setup in this dialog box. The Common Address of ASDU (CAA) for all
units is setup in the CAA Setting dialog box by pressing the Addr. Setting button.
Table 1: Configuration of IEC60870-5-103
Setting Description Default setting
Common Link layer
address
Link layer address used for all Units in
common
1
Baud Rate Baud rate 9600
Addr. Setting Individual Common Address of ASDU for
each Bay Unit
0 Central Unit
1-60 Bay Units
Section 3 1MRK 511 451-UEN B
Interbay bus functions
8 Distributed busbar protection REB500
Communication protocol manual IEC60870-5-103
© Copyright 2019 ABB. All rights reserved