1MRS750915-MUM
REM 54_
35
Machine Terminal
Technical Reference Manual, General
For more information about the configuration and the Relay Configuration Tool
refer to the Configuration Guideline and the tool manuals (see “Related documents”
on page 10).
5.1.2.2. MIMIC configuration
The control functions configured with the Relay Configuration Tool must be
associated with object status indicators that are part of the MIMIC configuration
picture displayed on the graphic LCD of the HMI. The MIMIC configuration picture
is designed with the Relay Mimic Editor. In addition, the editor is used to define the
eight programmable LED indicators and the corresponding alarm texts on the front
panel, the alarm modes, and the interlocking LED texts.
The MIMIC picture may include a single-line diagram, measured values with units,
free texts, etc. The object status indicators (open, closed, undefined) are drawn
according to the customer's requirements. Note that the operation of the objects
themselves is determined by means of the Relay Configuration Tool.
A060248
Fig. 5.1.2.2.-1 MIMIC configuration with the Relay Mimic Editor
The contents of the alarm view are configured with the Relay Mimic Editor by
defining the ON and OFF state texts (max 16 characters), refer to section “MIMIC
configuration” on page 35. For defining the corresponding LED colours refer to
section “Alarm LED indicators” on page 77.
To Next Page
Loading...
