ABB RER620 - Network Configuration; Physical Layer

Section 3 1MAC302441-MB A
IEC 60870-5-101/104 protocol implementation
40 RER620
Point List Manual
The possible selection (blank, X, R, or B) is specified for each specific Clause or
parameter.
NOTE: In addition, the full specification of a system may require individual selection of
certain parameters for certain parts of the system, such as the individual selection of
scaling factors for individually addressable measured values.
8.1 System or device
(system-specific parameter, indicate the station”s function by marking one of the
following with “X”)
8.2 Network Configuration
(network-specific parameter, all configurations that are used are to be marked “X” )
8.3 Physical Layer
(network-specific parameter, all configurations and data rates that are used are to be
marked “X”)
Transmission speed (control direction)
System definition
Controlling station definition (master)
X
Controlled station definition (slave)
X
Point-to-point Multipoint-party line
X
Multiple point-to-point Multipoint-star
Unbalanced interchange
Circuit V.24/V.28
Standard
Unbalanced interchange
Circuit V.24/V.28
Recommended if >1200 bit/s
Balanced interchange
Circuit X.24/X.27
100 bit/s
X
2400 bit/s
X
2400 bit/s 56000 bit/s
200 bit/s
X
4800 bit/s
X
4800 bit/s 64000 bit/s
X
300 bit/s
X
9600 bit/s
X
9600 bit/s
X
600 bit/s
X
19200 bit/s
X
1200 bit/s
X
38400 bit/s