IEC09000357 V1 EN
Figure 5: Select the TCP/IP protocol and open Properties
4. Select Obtain an IP address automatically if the parameter DHCPServer is
set to On in the IED.
IEC09000358 V1 EN
Figure 6: Select: Obtain an IP address automatically
5. Select Use the following IP address and define IP address and Subnet mask if
the front port is used and if the IP address is not set to be obtained
automatically by the IED, see Figure 7. The IP address must be different from
the IP address chosen for the IED.
Section 3 1MRK 504 126-UEN -
Starting up
24
Commissioning Manual
To Next Page
Loading...
