ABB S800 I/O - Page 28

*HQHUDO,QIRUPDWLRQDQG,QVWDOODWLRQ8VHU¶V*XLGH
&KDSWHU ,QWURGXFWLRQ
18 3BSE 020 923R101
 6XSSRUWIRU([WHUQDO,QWULQVLF6DIHW\6\VWHP
Beside S800 I/O modules with Intrinsic Safety Interfaces, Intrinsic Safety Systems
can be connected to the S800 I/O.
Intrinsic Safety System from ELCON Instruments (manufacturer outside ABB) is
supported via S800 I/O module and a special MTU.
Supported Intrinsic Safety System is the HiD Series 2000.
The S800 I/O modules are connected via MTU TU812, a standard cable and a
specific adapter board, one for each I/O module types.
For further information refer to ( OFRQ,QVWUXPHQWVPDQXDOV and ,QWUL QVLF6DIHW\
6XSSRUW 6,2ZLWK6HULHV .
The following I/O modules are supported:
AI810, AO810, DI810 and DO810.
See Figure 1-10 for an example of a connection between S800 I/O and Intrinsic
Safety System.
)LJXUH  ([DPSOHRI&RQQHFWLRQEHWZHH Q6,2DQG,QWULQVLF6DIHW\6\VWHP
IURP(/&21
S800 I/0
Intrinsic Safety System