15
PAINOS
PAINOS
Second setting of
SGF2 checksum
Second setting of
SGR2 checksum
Event (n-3)
value of phase L1
Event (n-4)
value of phase L1
Event (n-3)
value of phase L2
Event (n-4)
value of phase L2
Event (n-3)
value of phase L3
Event (n-4)
value of phase L3
Duration of event (n-3)
starting of stage I>
Duration of event (n-4)
starting of stage I>
Duration of event (n-3)
starting of stage I»
Duration of event (n-4)
starting of stage I»
Event (n-3)
value of current Io
Event (n-4)
value of current Io
Duration of event (n-3)
starting of stage Io>
Duration of event (n-4)
starting of stage Io>
Duration of event (n-4)
starting of stage Io»
Password for
altering settings
3
4
4
4
4
4
3
3
3
3
3
3
3
3
3
4
4
4
4
4
3
Number of low-set I>
starts since latest reset
Number of high-set I»
starts since latest reset
Number of low-set earth-
fault starts since latest reset
Number of high-set earth-
fault starts since latest reset
Duration of event (n-3)
starting of stage Io»
5
5
5
5
Main setting of
SGR3checksum
Second setting of
SGR3 checksum
5
6
1
2
3
5
6
7
8
9
A
Second setting of
SGF1 checksum
Second setting of
SGR1 checksum
Selection of main vs.
second setting
4
Operating time for the
CB-failure protection
5
C
The measures required for entering a submenu or a setting mode and how to perform the setting and use
the TEST mode are described in detail on Data Sheet 34 SPC 3 EN1 “General characteristics of the
D-type SPC plug-in units”. A short form guide to the operations is shown below.
Desired step or programming operation Push-button Action
Forward step in main or submenu STEP Press for more than 0.5 s
Rapid scan forward in main menu STEP Keep depressed
Reverse step in main or submenu STEP Press less than about 0.5 s
Entering to submenu from main menu PROGRAM Press for 1 s (Active on release)
Entering or leaving setting mode PROGRAM Press for 5 s
Increasing a value in setting mode STEP
Moving the cursor in setting mode PROGRAM Press for about 1 s
Storing a value in setting mode STEP&PROGRAM Press simultaneously
Resetting of memorized values and STEP&PROGRAM
latched output relays
Resetting of latched output relays PROGRAM Note! Display must be off
Note! All parameters which can be set in a setting mode are indicated with the symbol .
To Next Page
Loading...
