20
Code Event Weighting Default
factor
E17 TCO input activated 1 0
E18 TCO input deactivated 2 0
E19 RSV input activated 4 0
E20 RSV input deactivated 8 0
E21 Blocking input activated 16 0
E22 Blocking input deactivated 32 0
E23 U>, output signal activated 64 0
E24 U>, output signal deactivated 128 0
Default value of event mask V157 0
E25 I>, output signal activated 1 0
E26 I>, output signal deactivated 2 0
E27 U<, output signal activated 4 0
E28 U<, output signal deactivated 8 0
E29 Aut/Man output signal activated (automatic mode) 16 0
E30 Aut/Man output signal deactivated (manual mode) 32 0
E31 Parallel operation activated 64 0
E32 Parallel operation deactivated 128 0
Default value of event mask V158 0
E33 The measured voltage outside the bandwidth range 1 0
for 7 minutes
Default value of event mask V159 0
E50 Restarting of microprocessor * -
E51 Overflow of event register * -
E52 Temporary disturbance in data communication * -
E53 No response from the relay module over the SPA bus * -
E54 Relay module responds again over the SPA bus * -
0 not included in event reporting
1 included in event reporting
* no weighting factor
- cannot be programmed
To Next Page
Loading...
